To begin, let’s take a look at two paintings that exemplify the two major types of oil painting (alla prima and glazing). Here you can see how each approach results in a different sort of look, even when the subject matter is similar. The first, “Carnation, Lily, Lily, Rose”, 1885-1886, is by John Singer Sargent. It may not look all that loose, but keep in mind that the painting is very large (68×60″). The second is by a master of the glazing technique, Maxfield Parrish. It’s called “The Lantern Bearers”, executed in 1910.
And here are two landscapes for comparison. The first is by contemporary artist Richard Schmid, the second once again by Maxfield Parrish. Here, the difference in approach is more obvious. In Schmid’s work, the hand of the artist is very much part of the work; in Parrish’s work, it’s nearly invisible.
Maxfield Parrish achieved his jewel-like colors by employing many layers of pigment, each sealed by a layer of varnish. He used colors straight from the tube, allowing the transparent glazes to optically mix, much like in a watercolor. It was a very time-consuming process, since it required drying time between layers of paint and varnish. The alla prima method, on the other hand, is fast. To emulate Parrish’s method using Corel Painter, you would use (obviously) layers, and just skip the varnish! In a future tutorial, we’ll take a look at how to do a master-copy of Parrish’s work using Corel Painter. To emulate Schmid’s alla prima technique in Painter, you would stick to a single layer (the Canvas), and mix your colors using the Mixer palette.
That’s all pretty obvious stuff, I suppose, but what if you wanted to use color cloning? Can you get that fresh, loose look while cloning? The answer is yes, and the trick is to use Quick Clone. When I’m working on a portrait that needs to look “painterly,” I usually begin with a blank canvas, and pull the color from the original image onto the canvas. I don’t use the Clone brushes, usually, since they will pull in too much detail, and that’s not the look I’m after. To begin, open your file in Painter, and then go File > Quick Clone. In the upper right corner you’ll see a drop-down that allows you to adjust the transparency of the tracing paper. To make sure the tracing paper is turned on, go CMD+T(Mac) or CTL+T(Windows). This is a toggle, that will turn it on and off. In the screen shot below, I’ve got the clone open and positioned above the original, and I’m selecting 80% opacity for my tracing paper.
You can use any brush you like to begin “blocking in” the color. For this example, I’ll use the Acrylics variant Captured Bristle. Set it to 90% opacity, 50% resat, and a good firm stroke to bring in the color. Leaving the tracing paper turned on, but faint (like around 80%) allows you to stroke along the forms in the image, such as the figure and the tree branches. For areas with lots of small detail, look for the larger forms that contain those details. Use a big brush, like size 60 or greater. (If your image is small, 60 may be too big.)
Taking my time and being somewhat careful, one hour later I have the following image. You could, at this point, use a Soft Cloner at low opacity to bring out some of the foliage details, and refine the figure. Just don’t get carried away, or it’ll turn back into a photograph! I hope this quick exercise gives you ideas for new approaches to your painting. Let us know how you do!
- Tutorial: Painting Curly Hair in Corel Painter
- Tutorial: From Photo to Painting using Painter’s Quick Clone
- Tutorial: Basic Portrait Painting Technique for Corel Painter
- Tutorial: Painting Clouds with Corel Painter
- Tutorial: Create a Watercolor Portrait with Corel Painter
- Tutorial: An Easy Pet Portrait in Pastel with Corel Painter
- Tutorial: How to Use a Line Drawing with Corel Painter